The Armattan Gecko has a lot going on in the body due to constrained space. Putting the battery strap there wasn’t the best solution and could catch wiring.

This simple, light weight, battery strap holder allows you to secure battery from the bottom plate.

Requires a longer strap (150mm or longer).

Printed with 10% infill, 0.15 layer height in Fillamentum 98A TPU

Shift cap on 2004 F150 FX4 broke and the replacement was expensive. I printed mine in translucent purple Prusament PETG. This will be pressure fitted but can be lightly tacked with glue.

Print this in PETG, infill of choice, 0.15mm Layer Height

Plastic ABS pins on Amazon are too short for hay bales. I designed this to have a longer center pin.

Print this ins PETG, infill of choices (15%), 0.15mm Layer Height. Upside down.